Adjusting The Handle Height - Toro 30319 Operator's Manual

Adjusting the Handle Height

The handle position can be adjusted to match the
operator's height preference.
1. Remove hairpin cotter, washer and clevis pin
securing control rod fitting to idler bracket
(Figure 27).
Figure 27
1. Control rod and tting
2. Idler bracket
3. Clevis pin
2. Loosen the upper flange bolts (3/8 x 1 inch)
and flange nut securing handle to rear frame
(Figure 28).
Figure 28
1. Upper handle
2. Rear frame
3. Flange nut, (3/8 inch)
4. Flange bolt, (3/8 x 1 inch)
3. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 26).
4. Washer
5. Hairpin cotter pin
6. Rod tting
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
4. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch) and
flange nuts into mounting holes. Tighten all
flange bolts.
5. Thread rod fitting up or down on rod until
proper position is attained and install into
fitting to idler bracket with clevis pin, washer
and hairpin cotter. Refer to Installing the
Control Rods in Setup, page 11.
6. Check the parking brake adjustment. Refer to
Checking the Brakes in Brake Maintenance,
page 36.
26