D-Link DIR-320 User Manual page 37

DIR-320 Wireless N150 Router with 3G/CDMA/LTE Support
and USB Port
User Manual
Control
Save
Reboot device
Get config backup
Restore config
Reset to factory
Update firmware
Wi-Fi
Unmount storage
Click the icon to save new settings to the non-volatile memory.
Also you can save the device's parameters via the Save button on
the System / Configuration page.
Click the icon to reboot the device. All unsaved changes will be lost
after the device's reboot.
Click the icon to save the configuration (all settings of the router) to
your PC. The configuration backup will be stored in the download
location of your web browser.
Also you can create the configuration backup via the Backup
button on the System / Configuration page.
Click the icon to go to the System / Configuration page.
Click the icon to restore the factory default settings. Also you can
restore the factory defaults via the Factory button on the System /
Configuration page.
Also you can restore the factory default settings via the hardware
RESET button. The button is located on the back panel of the router
next to the power connector. Push the button (with the router
powered on) and hold for 10 seconds. Then release the button.
Click the icon to update the firmware of the router.
Also you can update the firmware on the System / Firmware
upgrade page.
Click the icon to disable or enable the device's WLAN.
Also you can disable/enable the router's WLAN on the Wi-Fi /
Basic settings page.
Click the icon to safely disconnect the USB storage.
Also you can safely disconnect the USB storage on the USB
storage / Information page.
Page 37 of 220
Installation and Connection
Description