Table of Contents
Advertisement
A Guide to TracVision L3
2-18
• Transponder information for each of the following
polarizations/frequencies:
- vertical high & vertical low
- horizontal high & horizontal low
• Transponder information includes:
- frequency
- symbol rate
- FEC code, and
- network ID (in hexidecimal format)
• Decoder type
This information can be obtained from your satellite service
provider or from sites on the Internet, such as www.satcodx.com.
For your reference, the satellite configuration information for the
predefined satellites has been provided in Appendix D.
Entering User-defined Satellite Data
Once the link between the PC and the TracVision L3 is
established as described in Section 2.4, "Selecting the Active
Satellite," it is necessary to provide initial longitude data
regarding the user-defined satellite. To do so, enter the
SATCONFIG parser command via PC as follows:
Command:
SATCONFIG,USERX,YYY,Z,D,L<cr>
Where:
X = 1 or 2 (satellite alternative)
YYY = longitude (0-180)
Z = E (East) or W (West)
D = decoding type (0=test, 1=DSS-A, 2=DSS-B,
3=DVB)
L = LNB polarization (C=circular, L=linear)
Function:
configures one of the user-configurable satellites
with the longitude provided
Response:
if valid entry, echoes the input data
if invalid entry, returns error message
Advertisement
Table of Contents
Troubleshooting
