Figure 2-10 Cable Port Assignments (Exterior Of Baseplate) - KVH Industries TracVision L3 Owner's Manual

TracVision L3 Cable Ports
On one side of the baseplate are four liquid-tight fittings, which
serve the dual purpose of relieving strain on the cables as well as
providing a tight seal around the cable access ports.
Used only with
N. American Systems
When wiring is done properly, the sets of cables will overlap each
other, as illustrated in Figure 2-11.
A switchplate has been provided to serve as the hub of the
TracVision L3 wiring (with the exception of the RF cable, which
will be connected to the IRD). This switchplate includes an
ON/OFF switch and a DB9 maintenance port for easy access to
the Antenna Unit's software and diagnostics. Follow these steps
to begin the wiring process.
1. Select a location to mount the TracVision L3
switchplate. It should be flat and within reach of
the cables connected to the Antenna Unit.
2. Create a panel cutout in the mounting surface.
Figure 2-12 on the following page illustrates the
mounting dimensions and a template has been
provided in Appendix C.
54-0157 Rev. C
Figure 2-10
Cable Port Assignments
(Exterior of Baseplate)
Figure 2-11
Cable Overlap within the
TracVision L3 Baseplate
Installation
2-7