Related Manuals for AFi MT-944C-SL
Summary of Contents for AFi MT-944C-SL
- Page 1 Instruction Manual MT-944C-SL Four Channel Video Transmitter With One Bi-Directional Multi-Protocol Data Channel 10/30/2012 JPK...
-
Page 2: Table Of Contents
Data Input / Output Connections ..............4 Typical System Data Connections............... 5 Data Configuration Switches ............... 5 Data Termination And Offset Bias Switches..........6 RS485 Data Termination And Offset Bias ........... 6 MT-944C-SL Status LED Indicators ............7 Warranty and Service Information ............... 8... -
Page 3: Functional Description
FUNCTIONAL DESCRIPTION The MT-944C-SL operates as half of a transmitter / receiver pair for the digital transmission of four simultaneous NTSC or PAL video signals along with one channel of field configurable bi-directional data.over one singlemode fiber optic cable. -
Page 4: Power Connection
POWER CONNECTION Power is supplied to the unit via a two pin terminal connector on the right side of the unit. Follow the label on unit for proper orientation of +12 volt dc and ground. FIBER CONNECTION The fiber optic connection is made via a ST connector located on the right side of the unit. VIDEO INPUT CONNECTIONS The video input connections are made via BNC connectors on the right side of the unit. -
Page 5: Typical System Data Connections
Correspondingly, the receiver of an electronic signal is labeled RX or Data In. Following this standard, the Data Out of the copper device is connected to the Data In of the MT-944C-SL. The plus terminal of the copper device is connected to the plus terminal of the MT-944C-SL and the minus is connected to the minus. -
Page 6: Data Termination And Offset Bias Switches
In order to reconfigure the RS485/422 channel, the module needs to be opened up. To open the MT-944C-SL, remove the end panel on the terminal block side and remove the screw on the bottom of the module. Slide the PCB assembly out about half way. The configuration switch banks are located at the center of the PCB in line with the DATA 1 terminal block. -
Page 7: Mt-944C-Sl Status Led Indicators
Data Flow Not Detected VLI 1 THROUGH VLI 4 A bi-color LED indicator is provided for each of the four video inputs to the MT-944C-SL. DC power and video status associated with each of these LED’s are summarized below. Video Presence LED... -
Page 8: Warranty And Service Information
LIFETIME WARRANTY INFORMATION American Fibertek, Inc warrants that at the time of delivery the products delivered will be free of defects in materials and workmanship. Defective products will be repaired or replaced at the exclusive option of American Fibertek. A Return Material Authorization (RMA) number is required to send the products back in case of return.