Related Manuals for AFi MT-926C
Summary of Contents for AFi MT-926C
- Page 1 Instruction Manual MT-926C Two Channel Video Transmitter With One Bi-Directional Multi-Protocol Data Channel And One Bi-Directional Contact Closure Channel 10/02/2012 JPK...
-
Page 2: Table Of Contents
Contact Closure Input / Output Connections ..........5 Data Configuration Switches ............... 5 Data Termination And Offset Bias Switches..........6 RS485 Data Termination And Offset Bias ........... 6 MT-926C Status LED Indicators ..............7 Warranty and Service Information ............... 8... -
Page 3: Functional Description
FUNCTIONAL DESCRIPTION The MT-926C operates as half of a transmitter / receiver pair for the digital transmission of two simultaneous NTSC or PAL video signals along with one channel of field configurable bi-directional data and one channel of bi-directional contact closure over one multimode fiber optic cable. -
Page 4: Power Connection
POWER CONNECTION Power is supplied to the unit via a two pin terminal connector on the right side of the unit. Follow the label on unit for proper orientation of +12 volt dc and ground. FIBER CONNECTION The fiber optic connection is made via a ST connector located on the right side of the unit. VIDEO INPUT CONNECTIONS The video input connections are made via BNC connectors on the right side of the unit. -
Page 5: Typical System Data Connections
Correspondingly, the receiver of an electronic signal is labeled RX or Data In. Following this standard, the Data Out of the copper device is connected to the Data In of the MT-926C. The plus terminal of the copper device is connected to the plus terminal of the MT-926C and the minus is connected to the minus. -
Page 6: Data Termination And Offset Bias Switches
In order to reconfigure the RS485/422 channel, the module needs to be opened up. To open the MT-926C, remove the end panel on the terminal block side and remove the screw on the bottom of the module. Slide the PCB assembly out about half way. The configuration switch banks are located at the center of the PCB in line with the DATA 1 terminal block. -
Page 7: Mt-926C Status Led Indicators
Contact Out Pins Open VLI 1 THROUGH VLI 4 A bi-color LED indicator is provided for each of the two video inputs to the MT-926C. DC power and video status associated with each of these LED’s are summarized below. Video Presence LED... -
Page 8: Warranty And Service Information
SYNC A bi-color LED indicator is provided to monitor the proper serialization of the electrical data stream through the MT-926C and out onto the fiber. DC power and sync status associated with this LED are summarized below. Sync LED DC Power Status...