Install Batteries In The Digital Atomic Clock; Install Batteries In The Outdoor Transmitter; Positioning The Atomic Clock; Postioning The Outdoor Transmitter - La Crosse Technology K86302 Instruction Manual

INSTALL BATTERIES IN THE DIGITAL ATOMIC CLOCK:

1. Remove battery cover: Slide tab to the down and pull out to remove
battery cover.
2. Install two fresh AA batteries according to the polarity markings.
Do Not Mix Old and New Batteries
Do Not Mix Alkaline, Lithium, Standard, or Rechargeable
Batteries
If the Digital Atomic Clock does not show indoor temperature after 60
seconds, remove batteries and wait for at least 60 seconds before
repeating the setup process.

INSTALL BATTERIES IN THE OUTDOOR TRANSMITTER:

POSITIONING THE ATOMIC CLOCK:

The Atomic Digital Wall Clock should be mounted near an exterior wall with the front or back facing toward Ft. Collin
Colorado for best WWVB reception. The Digital Atomic Clock should be six feet from other electronics or wireless devices
in order to best receive the outdoor temperature transmitter signal.
Foldout Table Stand:
A foldout table stand is located on the back of the clock.
Pull the stand out from the bottom center edge of the Digital Atomic Clock, below the battery
compartment.
Once the foldout table stand is extended, place the Digital Atomic Clock in an appropriate location.
Wall Mount
Use a straightedge to horizontally space three screw positions on a wall to match the hanging holes on the
back of the clock. Install three mounting screws (not included) into a wall within transmission range—
leaving approximately 3/16 of an inch (5mm) extended from the wall.
Place the Digital Atomic Clock onto the screws, using the hanging holes on the backside.
Gently pull the Digital Atomic Clock down to lock the screws into place.
Note: Always ensure that the Digital Atomic Clock locks onto the screws before releasing.
POSITIONING THE WIRELESS OUTDOOR TRANSMITTER:
Once the Digital Atomic Clock displays the outdoor temperature, place the clock and the transmitter in the desired
locations and wait approximately 1-hour before permanently mounting the transmitter to ensure that there is proper
reception.
The transmitter should be mounted vertically, in a shaded, protected area, at least 6 feet from the ground to avoid damage
and ensure accurate readings. The transmitter is water resistant, not waterproof and should not be placed anywhere it will
become submerged in water or subject to standing water or snow.
1. Slide the battery cover down, then lift off the back of the transmitter.
Note: Be careful not to break the tabs on the battery cover.
2. Insert two fresh AA batteries into the transmitter. Observe the correct polarity (see
marking inside battery compartment).
3. Keep transmitter 5-10 ft. from the Digital Atomic Clock during setup.
4.
After 15 minutes, if the outdoor temperature shows on the Digital Atomic Clock, you can
move the outdoor transmitter outside to a shaded location within range of the Digital
Atomic Clock.
7