Philips Lumea SC2004 User Manual page 27

Light-based hair removal
Hide thumbs Also See for Lumea SC2004:
Table of Contents

Advertisement

Available languages

Available languages

Problem
The 'ready to flash' light is
green but the appliance
does not produce a flash
when I press the flash
button.
The appliance becomes
warm during use.
The appliance does not
show light intensity 1
when I switch it on.
The appliance produces a
strange smell.
The skin feels more
sensitive than usual
during treatment.
I experience an
unacceptable pain
sensation when I use the
appliance.
Possible cause
Solution
The appliance
To reset the appliance, switch off the appliance and
needs to be reset.
switch it on again. If the 'ready to flash' light is green
but the appliance still does not produce a flash when
you press the flash button, contact the Consumer
Care Centre in your country, your Philips dealer or a
Philips service centre.
This is normal.
No action required.
The appliance
To reset the appliance, switch it off and on again. If the
needs to be reset.
appliance still does not show light intensity 1, contact
your Customer Care Centre, your Philips dealer or a
Philips Service Centre.
The attachment
Clean the attachment carefully. If you are unable to
and/or the filter
clean the attachment properly, contact the Consumer
glass is dirty.
Care Centre in your country, your Philips dealer or a
Philips service centre to replace the attachment.
You have not
If there are hairs on the area to be treated, these
shaved the area
hairs may get burnt when you use the appliance. As
to be treated
a result, you notice a strange smell. Shave the area to
properly.
be treated properly before you use the appliance. If
shaving causes skin irritation, trim hairs as short as
possible and use a comfortable setting.
You stored the
The strange smell disappears after a few flashes.
appliance in a
dusty environment.
The light intensity
Check if you have selected the right light intensity. If
you use is too high.
necessary, select a lower light intensity.
You did not shave
Shave the areas to be treated before you use the
the areas to be
appliance. If shaving causes skin irritation, trim hairs as
treated.
short as possible and use a comfortable setting.
The UV filter
If the UV filter of the light exit window is broken,
of the light exit
do not use the appliance anymore. Contact the
window is broken.
Consumer Care Centre in your country, your Philips
dealer or a Philips service centre.
The appliance is
Contact the Consumer Care Centre in your country,
defective.
your Philips dealer or a Philips service centre.
You did not shave
Shave the areas to be treated before you use the
the areas to
appliance. If shaving causes skin irritation, trim hairs as
be treated
short as possible and use a comfortable setting.
ENGLISH
27

Advertisement

Table of Contents
loading

Table of Contents