Table of Contents
Advertisement
-
To access the display for the MIN alarm values, the "MIN" touch screen field must be
pressed:
-
To return to the display for the MAX alarm values, the "MAX" touch screen field must be
pressed:
-
The individual outdoor sensors can be selected using touch screen fields 4 or 5 as in the
normal display mode.
-
Programming mode can either be exited immediately by pressing the "END" key (field 28), or
automatically 2 minutes after the last key has been pressed. In either case, the unit will
revert to normal mode.
-
To delete the alarm values, the "RESET" field (field 26) must be pressed for approx. 3
seconds.
3.4.2.
Setting/Resetting the MIN/MAX alarm values
-
After activating one of the alarm value displays (MIN or MAX), touch the value field for which
the alarm value is to be set.
-
The value will flash and the lower control field will change to the following form:
-
The flashing value can be adjusted using the "-" and "+" touch screen fields. It is possible to
run through the display more quickly by pressing the relevant touch screen field for longer.
-
If the "RESET" key is pressed while in this input mode, the alarm value will be deleted.
-
Pressing the "END" key terminates the input and stores the value.
-
The values for the alarms cover the ranges:
-
Temperature: -29.9ºC to 49.9ºC
-
-21.8ºF to 121.8ºF
-
Humidity:
20 %to 99 %
-
Wind speed: 0.0 km/h to 149 km/h
0.0 m/s to 41.9 m/s
0.0 mph to 92.9 mph
0.0 kn to 80.9 kn
-
Air pressure: 700 hPa to 1099 hPa
525 mmHg to 824 mmHg
20.65 inHg to 32.42 inHg
3.4.3.
Setting the wake-up times
Please note!
The wake-up time including the associated day can only be edited in the MAX alarm value
display.
-
The day for which the wake-up function is to be set can be set using the "DAY" field (field
27). The display "--" means that the wake-up time set applies to all 7 days of the week (daily
wake-up time).
-
Pressing touch screen field 21 activates the wake-up time (alarm symbol appears) or
deactivates the wake-up time (alarm symbol is crossed out).
-
To set the wake-up time, after setting the required day, press touch screen field 20, the time
will start to flash and can be adjusted using the "-" or "+" touch screen fields. It is possible to
run through the display more quickly by pressing this touch screen field for longer.
The following examples illustrate how the wake-up time is set and a deactivated and an activated
wake-up time.
Daily wake-up time 6:30, deactivated
-
You can store the wake-up time setting by pressing the "END" key.
3.4.4.
Alarm initiation, Alarm reset
-
If the measured value exceeds or falls below one of the set alarm values, the display will go
off and the alarm value in question together with the text "ALARM" and the appropriate high
or low deviation (MAX or MIN) will be displayed. At the same time, an intermittent alarm tone
will sound.
-
In addition, the point in time at which the alarm occurred will be shown in the time of day field
so that it is also possible to establish this time later.
-
The alarm is reset using the "RESET" key.
Wake-up Monday 7:00, activated
Advertisement
Table of Contents
