Table of Contents
Advertisement
Example for the display of maximum values
Example for the display of minimum values.
Display min/max values
-
The display mode is selected by touching the appropriate field "MAX" (field 27) or "MIN"
(field 25). The particular touch screen field activated (MIN or MAX) will be faded out. Both
titles are only visible in normal display mode.
-
If the touch screen field for a value is then pressed, the time of the occurrence associated
with this value will be displayed in the time/date field (20/21) for 10s.
-
If the touch screen field is pressed again while the time is being displayed, the display mode
for the value concerned will be stepped forwards.
Indoor sensor: Temperature -> Dewpoint ->
Outdoor sensor: Temperature -> Dewpoint -> Perceived temperature ->
The outdoor sensors are selected using touch screen fields 4 or 5 as with the normal
display.
Wind sensor: Wind speed: km/h ->m/s ->mph ->knots ->Beaufort ->
Rain sensor: Amount per day/hour: 24 h ->1 h ->
-
You can return to the normal display by pressing the "END" key.
Deleting min/max values
-
If the "RESET" field is pressed while the time of the minimum or maximum values is being
displayed, the value concerned will be deleted.
-
If the "RESET" field is pressed for 3 seconds, all the stored values will be deleted.
History display for min/max values
-
By using the SELECT function (touch screen field 16) and then selecting the required value,
the minimum/maximum trends of the individual values can also be checked depending on
the previous choice of the min/max function (see also the section "History").
Please note!
-
If not exited manually by pressing the "END" key, the min/max display will be terminated
automatically 2 minutes after the last key has been pressed and the unit will revert to normal
display mode.
-
Only the maximum value display is available for the rain and wind sensor.
-
In the case of the rain sensor, the display modes for the maximum value display are adapted
as follows:
Total: ->maximum value that occurred in the last 24 hour
Current 24h -> maximum value that occurred in the last 24h
24h -> maximum value that occurred in the last 24 h
Current hour -> maximum value that occurred in the last hour
1h -> maximum value that occurred in the last hour
-
In the case of the hours of sunshine, the "h/day" display mode is always set.
-
In the case of the wind speed display, the wind direction associated with the maximum value
that occurred will also be displayed concurrently.
3.4.
Programming mode (entering alarm values)
You can program the weather station so that an audible-visible alarm occurs when certain
minimum or maximum values are reached. As well as this, daily wake-up times can be
programmed so that the weather station can also be used as an alarm clock or an appointment
reminder.
Alarm values can be set for:
-High or low temperature for all sensors
- High or low humidity for all sensors with humidity
- High and low air pressure
- High wind speed
- Daily wake-up time
- Separate wake-up time for each day of the week
3.4.1.
Programming the min/max alarm values
-
The programming mode is selected by touching field 29 ("ALARM VALUES").
The display shown below is an example of how the screen appears for the MAX alarm
values and the daily wake-up time. If no alarm value has been set, dashes appear in place of
the value display. Wake-up times are only shown in the MAX display.
Advertisement
Table of Contents
