Table of Contents
Advertisement
2-9 Top Assembly To Upper Frame
Assembly Installation
Position the top assembly P#(A1158) above the upper
frame assembly as shown in Figure 2-9. Fasten the top
assembly to the upper frame assembly using (2) 5/16"-
18 x 2-1/2" HHCS P#(K0125) and (2) 5/16"-18 nylon
flange locknuts P#(K2516). Leave the locknuts slightly
loose, to allow the top assembly to open and close
easily. Refer to Figure 2-9 for hardware location.
Figure 2-9
Upper Frame
Assembly
(2) 5/16-18 x 2-1/2" HHCS
(2) 5/16"-18 Nylon Flange
Locknuts
2-10 Hinge Kit Assembly Installation
Assemble the hinge kit as shown in Figure 2-10, using
(2) 5/16"-18 x 1" HHCS P#(K1154), (3) 5/16"-18 nylon
flange locknuts P#(K2516), (5) 1/4" flat washers
P#(K0037) and (2) swing arm brackets P#(ZT-0004).
Place (1) vinyl cap P#(J0289) on the end of the hex bolts
as shown in Figure 2-10. Leave the nuts loose enough to
allow fluid movement of the top when opening and
closing. When opened, the top should rest on the middle
joint of the hinge allowing it to remain up.
Figure 2-10
K1154
K2516
J0289
ZT-0004
Top Assembly
K0037
2-11 Inlet Installation
Slide the inlet P#(V0025) into the hole on the bagger top
until the inlet locks into place. The inlet should pivot 360
degrees about the hole in the bagger top. Refer to
Figure 2-11.
Figure 2-11
Insert Inlet
From the Inside
of the Top Assembly
2-12 Exhaust Diverter Installation
To prevent the engine exhaust from damaging the
engine/blower/blade assembly, insert (1) exhaust
diverter P#(J0282) onto the end of the muffler exhaust
tube. Position the diverter so that the collection bags are
not in the path of the exhaust. Secure the exhaust
diverter with (1) exhaust clamp kit P#(X1064). Refer to
Figure 2-12.
Figure 2-12
Muffler
Exhaust Tube
Exhaust
Clamp Kit
11
Inlet
Exhaust
Diverter
Advertisement
Table of Contents
