Table of Contents
Advertisement
1-1 Introduction
We are pleased to have you as a PECO customer. Your
collection system has been designed to give you a low
maintenance, simple, and effective way to collect the
grass clippings from your mower. This manual is
provided to give you the necessary instructions to
properly mount and operate the collection system on
your mower. Please read this manual thoroughly.
Understand what each control is for and how to use it.
Observe all safety decal precautions on the machine and
noted throughout the manual.
NOTE: all references made to right, left, front, rear, top
or bottom are as viewed from the normal operator's
position on the mower.
2-1 Preparation of Mower
Remove the rear bumper and hardware from the mower
frame. Refer to Figure 2-1b and page 6 of your Snapper
Pro parts manual.
Section I
Introduction and Description
Section II
Preparation of Mower
Figure 2-1b
5
1-2 Description
The grass collection system is designed for turf
maintenance where there is a need to collect the grass
clippings as the mower cuts the turf. It is also used for
picking up leaves and in pre-season and post-season
clean-up. The blower, mounted on the right side of the
unit, is powered by Briggs & Stratton 900 Series or
6.5HP Vanguard. The blower draws grass clippings from
the discharge area of the cutter deck back to the (3) - 4.0
cubic foot collection bags P#(G0003) at the rear portion
of the mower frame. Once the bags are full with
clippings, they can be released to make for easy
dumping.
Page 6 Snapper Pro
Parts Manual
Remove
Rear Bumper
and Hardware
Advertisement
Table of Contents
