Table of Contents
Advertisement
2-7 Exhaust Diverter Installation
Insert the exhaust deflector P#(J0251) onto the end of
the muffler. Orientate the exhaust diverter to exhaust
towards the rear of the mower. The diverter is used to
keep the engine exhaust from burning the cloth bags,
and the PTO or engine/blower/blade assembly. Secure
the exhaust diverter with (1) exhaust clamp kit
P#(X1046). Refer to Figure 2-7.
Figure 2-7
Exhaust
Clamp Kit
2-8 PTO Mount Assembly Installation
PTO MODELS ONLY
NOTE: Continue to Section 2-13 on page 10 if you
are installing an engine driven unit.
Secure the PTO mount plate assembly P#(A1825) to the
rear bumper of the mower using (4) 3/8"-16 x 1" HHCS
P#(K1191) and (4) 3/8"-16 nylon flange locknuts
P#(K2038). Refer to Figure 2-8a.
Figure 2-8a
Rear
Bumper
(4) 3/8"-16 x 1" HHCS
(4) 3/8"-16 Nut
Exhaust
Diverter
PTO Mount
Plate Assembly
On all engine models with an engine oil drain hose on
the right side of the engine, attach the existing J-hook to
the rear bumper using the PTO mount assembly
hardware shown in Figure 2-8b.
Figure 2-8b
Engine Oil
Drain
J-Hook
2-9 PTO Assembly Installation
PTO MODELS ONLY
Insert the PTO assembly P#(A0623) into the PTO mount
plate assembly as shown in Figure 2-9a. The mount rod
on the PTO assembly slides into the mounting slots on
the PTO mount plate assembly. Secure the PTO
assembly with (1) mount pin P#(B0274) and (1) hair pin
clip P#(K0086) shown in Figure 2-9b. Remove the pulley
guard in preparation for the belt installation.
Figure 2-9a
Mount
Rod
Figure 2-9b
Mount Pin
8
Existing
Hardware
PTO
Assembly
Remove Pulley
Guard
Hair Pin
Clip
Advertisement
Table of Contents
