Table of Contents
Advertisement
3. Make sure all shields are in place and in good
condition. Repair or replace any missing or damaged
shields.
4. Perform lubrication per paragraph 4-2.
5. Listen for abnormal sounds, which might indicate
loose parts, damaged bearings, or other damage.
Correct any deficiency before continuing operation.
6. PTO MODELS ONLY: With the engine off, engage
the
blower assembly. Check the belt tension and inspect
the pulley belt for cracks or tears.
7. Check for wear or deterioration of the upper or lower
hoses. If there are any portions of the hose that have
been torn or worn through, replace with genuine
PECO parts.
After Each Use:
1. Clean all debris from machine especially from the
container, underneath the belt shields, and safety
decals. Replace any missing or illegible decals.
2. Inspect the unit for worn or damaged components.
Repair or replace before the next use. Any
replacement component installed during repair shall
include the component's current safety decal specified
by the manufacturers to be affixed to the component.
3. PTO MODELS ONLY: Check belt for proper tension.
THE SERIAL NUMBER PLATE
IS LOCATED ON THE TOP
ASSEMBLY P#(A1157)
Unit Model Number: _____________________________
Unit Engine Size:
Unit Serial Number: _____________________________
Date of purchase: _____/_____/_________
Dealer/Distributor Name: ________________________________________
Address: _____________________________________ State: __________ Zip:__________
Phone Number: ____________________________
PECO
OUTDOOR POWER EQUIPMENT
Model Number
Serial Number
Arden, North Carolina 28704
_____________________________
24
4-2 Lubrication For PTO Models
NOTE: Use only white lithium based grease for
lubrication of the shaft on the blower assembly.
1. On initial use: Grease the fitting on
the blower shaft.
2. Every 25 hours of use: Re-grease the
grease fitting.
3. Every 200 hours of use: Check oil levels in gear box.
Oil in gear box should cover the gears. If necessary,
fill using an EP90 weight oil. 6oz. will fill the gear box
from empty.
SECTION V
PARTS AND SERVICE
5-1 Parts And Service Information
PECO collection system owners should record the name
and telephone number of their Service Center. Your
Service Center will be happy to supply replacement
parts, accessories, and do any service or repairs to your
collection system. If for any reason your Service Center
is unable to service your collection system or supply
replacement parts, contact PECO and include the
following information on the chart below.
BOX ABOVE FOR FUTURE
WRITE THE MODEL AND
SERIAL NUMBER IN THE
REFERENCE.
Advertisement
Table of Contents
