Adjust Individually; Tips For The Automatic Programmes - Bosch HBG78B9.0 Instruction Manual

Hide thumbs Also See for HBG78B9.0:

Instruction manual (40 pages)

Table Of Contents

Table of Contents

Select the programme group by turning the rotary selector.

Press the

button to change the line.

Use the rotary selector to select the programme.

In some of the programmes, you can make further

specifications, e. g. Joint of veal option, followed by Lean joint

or Marbled joint. Press the

selection using the rotary selector.

A suggested weight appears for the programme selected.

Press the

button.

Use the rotary selector to specify the weight of the dish.

If you switch to the lower line, you can alter the cooking result

(see Adjust individually).

Tips for the automatic programmes

The weight of the joint or poultry is

greater than the weight ranges availa-

ble.

The joint has cooked well, but the juices

are too dark.

The joint has cooked well, but the juices

are too clear and watery.

The joint is too dry on the top.

The joint looks good, but there was a

burning smell during roasting.

You wish to prepare frozen meat.

The meat is not cooked well enough or

is too well cooked.

EURO Appliances - euappliances.info

button and make your

The weight range is deliberately limited. For very large joints, it is often impossible to

obtain a sufficiently large roasting dish. Prepare large pieces with

Hot air grilling.

Select a smaller dish or use more liquid.

Select a larger dish or use less liquid.

Use a dish with a tightly fitting lid. Very lean meat will remain more succulent if it is cov-

ered with rashers of bacon.

The lid of the roasting dish is not closed properly, or the meat has expanded and has

pushed up the lid. Always use the right lid for your ovenware. Make sure that there is at

least 3 cm between the meat and the lid.

Season frozen meat in the same way as fresh meat. Caution: For frozen meat it is not

possible to delay the end time. The meat would defrost during the waiting time and would

be inedible.

Change the settings the next time. You will find information on this in the Automatic pro-

grammes, Individual Settings section.

Press the

button.

The programme starts. You can see the cooking time

counting down in the status bar.

The programme has ended

A signal sounds. The oven stops heating. You can cancel the

signal earlier by pressing the

time in the status bar is 00:00:00.

Cancelling the programme

Press and hold the

button until 3D hot air, 160 °C appears.

You can now change the settings.

Calling up information

Press the

button briefly. Check each item of information using

the rotary selector.

Setting a later end time

See the section entitled Time-setting options - Setting a later

end time.