Preselection Of Running Time - Hermle Z 326 K Operating Manual

OPERATION

2.3.2 Preselection of running time

The running time can be pre-selected in three different ranges from 10 seconds up to 99 hours 59
minutes.
1. Range from 10 seconds up to 59 minutes 50 seconds in steps of 10 seconds
2. Range from 1 hour up to 99 hours 59 minutes in steps of 1 minutes
3. Range continuous run „cont", which can be interrupted by the key "stop" (10).
The running time can be pre-selected with the lid open or closed.
To activate the setting of the running time press the key „time" (6).
In the display „time" (A-3) flashes the indication „m : s" or „h : m", depending on the previous
setting.
To set the desired value use the adjusting knob (1). After exceeding of 59 min 50 sec the indication
changes automatically into „h : m". After exceeding of 99 hours 59 min the word „cont" appears in
the display „time" (A-3). That continuous run can only be interrupted by pressing the key „stop" (10).
The time countdown as soon as the set speed is reached.
The display shows always the remaining running time. (see figure 19)
All with number marked passages refer to figure 19
Figure 19
20
Z326K_V3.15 © Hermle Labortechnik GmbH