Volume Pre-Selection Of Sound Signal; Song Selection For Sound Signal - End Of Run - Hermle Z 326 K Operating Manual

PRODUCT DESCRIPTION

1.8.4 Volume pre-selection of sound signal

Proceed as described under point 1.8.1 to enter this program mode and then press the key
„accel/decel" (5). In the display „accel/decel" (A-2) flashes the word „service". Now select the letter
„U" with the adjusting knob (1). As a result appear in the display „rpm/rcf" (A-1) the words
„Vol=0- 9/Sound". After pressing the key „rpm/rcf" (4), you can adjust the desired volume between 0
(low) and 9 (loud) with the adjusting knob (1) (see figure 6).
After you have stored the settings (see 1.8.1) you changed to the normal program mode again by
switch off the centrifuge for a short while.
Figure 6

1.8.5 Song selection for sound signal - end of run

Proceed as described under point 1.8.1 to enter this program mode and then press the key
„accel/decel" (5). In the display „accel/decel" (A-2) flashes the word „service". Now select the letter
„G". with the adjusting knob (1). As a result appears in the display „rpm/rcf" (A-1) the word „
SonGo/Sound". After pressing the key „rpm/rcf" (4), you can select a song with the adjusting knob
(1). (see figure 7).
After you have stored the settings (see 1.8.1) you changed to the normal program mode again by
switch off the centrifuge for a short while.
Figure 7
12
Z326K_V3.15
9
8
1
7
© Hermle Labortechnik GmbH