Call Up Operating Data (By Skilled Or Service Engineer Only!) - Hermle Z 326 K Operating Manual

PRODUCT DESCRIPTION

1.8.7 Call up operating data (by skilled or service engineer only!)

In the mode „Basic Adjustments" you can call up the operating data of the centrifuge. Please
proceed as described under point 1.8.1 to enter this program mode. Press the key „accel/decel" (5).
In the display „accel/decel" (A-2) flashes the word „service".
With the adjusting knob (1) the different information can be called up:
A = previous starts of the centrifuge
H = previous operating hours
S = software version
r = converter software
E = list of previous error massage
h = running time of the motor
The list of the last 99 error messages can be looked over by pressing the key „rpm/rcf" (4) and scroll
through it by the adjusting knob (1). The respective error codes appear in the display „rpm/rcf" (A-1).
Please look up in „Table 6: error messages" (see APPENDIX S. X).
Here as well you must shortly switch off the centrifuge for changing to the normal program mode
again.
Figure 9
14
Z326K_V3.15 © Hermle Labortechnik GmbH