Canon ZR600 Instruction Manual page 77

7. Press the AUDIO DUB. button on the wireless
controller.
"AUDIO DUB." and"
=
II"
appear.
8. Press the PAUSE II button on the wireless controller
to begin dubbing.
•
~
Audio device: Begin playback.
• Microphone: Speak into the microphone.
9. Press the STOP. button on the wireless controller
to stop dubbing.
~
Audio device: Stop playback.
II
S? S2 :2
S1DD
~~o
I ~I
ZERO SET
AUUluDUB.MEMORY lVSCREEN
,-....,-....
,-....
~~~
c5C:So
AUDIODUB.
Z Jf3oW
lVSCREEN
,-....,-....
,-....
a
Use only tapes recorded in SP mode 12-bit audio sound with this camcorder.
Audio dubbing will stop if the tape has a blank section or a section recorded in
LP mode or 16-bit mode.
a
You cannot use the DV terminal for audio dubbing.
a
If you add sound to a tape not recorded with this camcorder, sound quality may
decrease.
a
Sound quality may decrease when you add sound to the same scene for more
than 3 times.
a
When you connect an audio device, check the picture on the LCD screen and
the sound via built-in speaker or audio device.
a
When you use the microphone, you can check the picture on a TV connected
via the AV terminal and the sound via headphones connected to the TV.
a
Set the zero set memory at the end of the scene you wish to audio dub. The
camcorder will automatically stop audio dubbing at that point.
-
77