Adjusting The Clutch Cable Free Play - Yamaha MT-03 Service Manual

CAUTION:
The engine oil tank must be filled with
engine oil in two steps. First, fill the engine
oil tank with 2.0 L (2.11 Imp qt, 1.75 US qt)
of the recommended engine oil. Then, start
the engine, race it five or six times, turn it
off, and then add the remainder of the
engine oil.
Quantity
Total amount
3.40 L (2.99 Imp qt, 3.60 US qt)
Without oil filter element
replacement
3.00 L (2.64 Imp qt, 3.17 US qt)
With oil filter element
replacement
3.10 L (2.72 Imp qt, 3.28 US qt)
10.Install:
• Engine oil tank dipstick
11.Start the engine, warm it up for several min-
utes, and then turn it off.
12.Check:
• Engine (for engine oil leaks)
13.Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-9.
14.Check:
• Engine oil pressure
a. Slightly loosen the bleed bolt "1
b. Start the engine and keep it idling until en-
gine oil starts to seep from the bleed bolt. If
no engine oil comes out after one minute,
turn the engine off so that it will not seize.
1
3-11
c. Check the engine oil passages, the oil filter
element, and the oil pump for damage or
leakage. Refer to "OIL PUMP" on page 5-41.
d. Start the engine after correcting the prob-
lem(s) and check the engine oil pressure
again.
e. Tighten the bleed bolt to the specified torque.
Bleed bolt
5 Nm (0.5 m·kg, 3.6 ft·lb)
EAS00078
ADJUSTING THE CLUTCH CABLE
FREE PLAY
1. Check:
• Clutch cable free play "a"
Out of specification
Clutch cable free play
(at the end of the clutch lever)
10.0-15.0 mm (0.39-0.59 in)
2. Adjust:
• Clutch cable free play
Handlebar end
a. Slide back the rubber cover "3".
b. Loosen the locknut "1".
c. Turn the adjusting bolt "2" in direction "b" or
"c" until the specified clutch cable free play is
obtained.
Direction "b"
Clutch cable free play is increased.
Direction "c"
Clutch cable free play is decreased.
d. Tighten the locknut.
e. Slide the rubber cover to its original position.
ENGINE
Adjust.