Installing The Swingarm - Yamaha MT-03 Service Manual

4. Check:
• Thrust covers
• Dust seal
• Oil seals
Damage/wear Replace.
• Ball joint
• Bearings
Damage/pitting
• Collars
• Spacers/Bush
Damage/scratches
EAS23380

INSTALLING THE SWINGARM

1. Lubricate:
• Bearings
• Ball joint
• Spacers/Bush
• Pivot shaft
Recommended lubricant
Lithium-soap-based grease
2. Press in their seats
• Bearings "1"
Location "a" of bearings
(right and left)
9 mm (0.354 in)
Replace.
Replace.
• Ball joint "2"
Location "b" of ball joint
5 ± 0.5 mm (0.196 ± 0.0196 in)
3. Install:
• Bushes "3"
• Plate washers "4"
• Thrust covers "5"
• Dust seals "6"
• Collars "7"
4. Install:
• Swingarm
(locate it in its position on frame)
• Plate washer
• Pivot shaft
• Self-locking nut
5. Tighten:
• Self-locking nut
Pivot shaft self-locking nut
92 Nm (9.2 m·kg, 66 ft·lb)
6. Install:
• Rear shock absorber assembly
Refer to "REAR SHOCK ABSORBER
ASSEMBLY" on page 4-60.
• Rear wheel
Refer to "REAR WHEEL" on page 4-12
7. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-22.
Drive chain slack
40.0–50.0 mm (1.57–1.97 in)
4-66
SWINGARM
New