Transportation Instructions; Installation Instructions - Beko CNP1601ES Manual

Transportation
Instructions
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of
transport the appliance has to be
transported horizontally, it must only
be laid on its right hand side when
standing in the frontof the appliance.
After bringing it to upright position,it
must not be operated for at least 4
hours to allow the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be
protected against rain, moisture and
other atmospheric influences.
5. When positioning your
appliance take care not to damage
your flooring, pipes, wall coverings
etc. Do not move the appliance by
pulling by the door or handle.
6. Empty any water in the drain
tray before moving. See section
'Defrosting' and 'Care & cleaning' for
further information.
7. Make sure that the defrost
water pipe at the back of the product
is fixed to the plastic evaporating pan
on the top of the compressor, to avoid
defrost water spillage on the floor.
Important : Care must be taken
while cleaning / carrying the
appliance to avoid touching the
bottom of the condenser metal wires
at the back of the appliance as you
might injure your fingers and hands.
Do not attempt to sit or stand on top
of your appliance as it is not designed
for such use. You could injure yourself
or damage the appliance.
Important : Make sure that mains
cable is not caught under the
appliance during and after carrying
/ moving the appliance, to avoid
the mains cable becoming cut or
damaged."
Do not allow children to play with the
appliance or tamper with the controls.
Beko declines to accept any liability
should the
followed.
Important : This appliance is not
designed for stacking with any other
appliance.When positioning your
appliance, take care not to damage
your flooring, pipes,wall coverings
etc.

Installation Instructions

1. The space in the room where
the appliance is installed must not be
smaller than 10 cubic metres.
2. Do not place the appliance
near cookers, radiators or in direct
sunlight as this will cause your
appliance to work harder. If installed
next to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers 50 mm (2")
From Radiators 300 mm (12")
From Freezers 25 mm (1")
3. Make sure that sufficient room
is provided around the appliance to
ensure free air circulation. Fit the two
plastic wall spacers supplied with the
appliance to the condenser on the
back of the appliance by rotating 1/4
turn. (See Diagram).
13
EN
instructions not be