Table of Contents
Advertisement
Dispensing buttons
This function enables or not the buttons on the coin
mechanism used to release the coins in the change return
tubes.
Value of "exact amount"
This value defines the combination of empty coin tubes,
setting the coin mechanism in "exact amount" mode. The
possible combinations of empty coin tubes are indicated
below.
For greater simplicity, the combination is described with
reference to tubes A, B and C, where tube A receives the
lower value coins and tube C the greater value coins.
0
=
1
=
2
=
3
=
4
=
5
=
6
=
7
=
8
=
9
=
10
=
11
=
12
=
C.P.C. device
It dialogues with the coin mechanism if devices are in-
stalled or removed from the serial interface (C.P.C.-type
devices - the monitoring unit is always enabled by default).
Minimum level of tubes
It brings forward the "Insert exact amount" message for the
user, by adding a number of coins between 0 and 15 to the
programmed number of coins, to set the "full change
tubes" status.
Free Vend VMC
Most payment systems with the BDV protocol control the
free vend function.
However, there are some payment systems without such
function.
In this case, if free selections are to be dispensed, free
vending must be enabled with VMC (vending machine
control, enabled by default) and the price of the selections
must be set to zero.
MDB
The MDB protocol menus are used for defining the follow-
ing functions:
Type of vending
Setting the operating mode for multiple or single dispens-
ing. With multiple dispensing, the change is not automati-
cally returned after a successful selection; however the
credit is available for further selections. When pressing the
coin return button (if the function is enabled), the available
credit is returned up to the maximum change value.
Credit control
To enable/disable the operation of the coin return button.
© by N&W GLOBAL VENDING S.p.A.
A or (B and C)
A and B and C
A and B only
A and (B or C)
A only
A or B (default) only
A or B or C
A or B only
A or C only
B and C only
B only
B or C only
C only
Maximum credit
This function is used to define the maximum accepted
credit.
Maximum change
It is possible to set a limit to the total amount of change
returned by the coin mechanism when pressing the coin
return button or after a single dispensing serving.
Any credit exceeding the amount programmed with this
function will be cashed.
Accepted coins
It is possible to define which, among the coins recognised
by the validator, are to be accepted when the change tubes
are full.
Check the coin mechanism configuration for the correct
coin to value matching.
Returned coins
It is possible to define which, among the coins available in
the tubes, are to be used for returning the change. This
parameter is active only with coin mechanisms that do not
automatically control the choice of tube to be used (Auto
changer payout).
Check the coin mechanism configuration for the correct
coin to value matching.
Accepted bills
It is possible to define which, among the bills recognised
by the reader, are to be accepted.
Check the reader configuration for the correct bill to value
matching.
Minimum level of tubes
This function is used for setting the number of coins (0 to
15) to determine the status of full change tubes and the
"Insert exact amount" message for the user.
Accepted coins with "exact amount"
It is possible to define which, among the coins recognised
by the validator, are to be accepted when the machine is
in the "exact amount" condition.
Check the coin mechanism configuration for the correct
coin to value matching.
Accepted bills with "exact amount"
It is possible to define which, among the bills recognised
by the accepter, are to be accepted when the machine is
in the "exact amount" condition.
Check the accepter's configuration for the correct bill to
value matching.
23
1006 83288-00
Hide quick links:
Advertisement
Table of Contents
