Craftsman 235.185930 Owner's Manual page 13

Reverse
Valve
Tab
Figure 14
If the tab on the reverse Valve
has been rotated to the right,
install the left Button. See Fig-
ure 15.
Reverse
Valve
Reverse
Figure 15
Button
NOTICE:
If the Forward/Re-
verse Buttons will not install
easily, move the Reverse Valve
slightly higher in the handle to
provide better alignment with
the Buttons.
7. After the Forward/Reverse But-
tons have been installed, re-
move the Trigger before pro-
ceeding with installation of the
throttle mechanism.
Assembly of Throttle Mecha-
nism
1. Using an Inlet Bushing Screen
Installation Tool, install the Inlet
Bushing Screen (24), screened
end first, in the bottom (hex
end) of the Inlet Bushing (23).
Insert the rounded end of the
tool in the cone formed by the
screen and tap the end of the
tool to secure the rim of the
screen in the Bushing.
2. Install the Inlet Retainer Clip
(25), Inlet Bushing Seal (27),
Tilt Valve Spring (28), Tilt Valve
(29), Tilt Valve Seat (30) and Tilt
Valve Seat Support (31).
Rear of
Housing
Forward
Button
Rear of
Housing
Tab
13
WARNING:
The Tilt Valve Seat Retainer
(32) must be properly installed
in the groove in the Inlet Bush-
ing (23). Failure to do so could
result in injury. To check for cor-
rect installation of the Retainer,
insert a pin into one of the holes
in the Retainer and rotate the
Retainer. A correctly installed
Retainer will rotate freely but
with some resistance in the
groove of the Inlet Bushing. An
incorrectly installed Retainer will
pop out of the Inlet Bushing
when the Retainer is rotated.
WARNING:
Do not use compressed air to
check installation of the Tilt
Valve Seat Retainer or Inlet
Bushing Screen unless the en-
tire Inlet Bushing Assembly is
installed in the tool with the
Hammer Case installed and
properly secured to the Motor
Housing. Failure to do so could
result in injury.
3. Install the Tilt Valve Seat Re-
tainer.
NOTICE:
When re-installing
the Inlet Bushing Assembly, pull
the Trigger (33) outward and
make sure that the Reverse
Button (40) is depressed before
snapping the Inlet Bushing As-
sembly back into the Housing.
4. Install the Inlet Bushing Assem-
bly by pushing it into the hole in
the Housing until you see and
hear the tabs on Inlet Retainer
Clip snap into place through the
slots in Housing handle.
NOTICE:
The Reverse Button
(left) (40) must be pushed in be-
fore the Trigger can be
installed. Otherwise, the Trigger
will be damaged during installa-
tion.
5. Install the Trigger by pushing it
into the handle until a click is
heard indicating that it is prop-
erly engaged.