Installing The Fuse; Installing The Starter Rope; Filling The Engine With Oil; Charging The Battery - Toro Recycler 20793 Operator's Manual

Figure 7
1. Handle bracket (2)

2. Installing the Starter Rope

Pull the starter rope through the rope guide on the handle
(Figure 8).
Figure 8
1. Starter rope

3. Filling the Engine with Oil

Your mower does not come with oil in the engine.
1. Remove the dipstick (Figure 9).
Figure 9
2. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 9). Do not
overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30W
2. Rope guide
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer
to Changing the Engine Oil.

4. Installing the Fuse

Model 20795 only
Your mower comes with a 40-amp fuse that protects the
electric starter.
Important: You cannot start the mower with the
electric starter or charge the battery unless you install
the fuse.
1. Unclip both ends of the battery cover and remove it
(Figure 10).
Figure 10
2. Install the fuse in the fuse holder (Figure 11).
Figure 11
Note: Your mower comes with a fuse in the your
owner's packet and another fuse in the battery box.
3. Install the battery cover.

5. Charging the Battery

Model 20795 only
Refer to Charging the Battery in the Maintenance section.
7