Replacing the Air Filter
Replace the air filter yearly; replace it more frequently in
dusty operating conditions.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Use a screw driver to open the air filter cover (Figure
44).
Figure 44
3. Replace the air filter.
4. Install the cover (Figure 45).
Figure 45
Changing the Engine Oil
Change the engine oil after the first 5 operating hours;
change it yearly thereafter.
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Remove the dipstick (Figure 46).
Figure 46
3. Tip the mower onto its side, with the air filter up, to
drain the used oil out through the oil fill tube (Figure
47).
Figure 47
4. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 48). Do
not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30W
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
Figure 48
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
17