Using The Self-Propel Drive; Engaging The Blade - Toro Recycler 20793 Operator's Manual

Figure 25
•
If the mower does not start in 1 or 2 pulls (or 5
seconds using the electric starter), press the primer
button 1 or 2 times and try starting it again.
Note: If the mower still does not start, contact an
Authorized Service Dealer.

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your sides,
and the mower will automatically keep pace with you
(Figure 26).
Note: You can self-propel the mower with the blade
engaged or disengaged.
Figure 26
Stopping the Engine (Model
20793 only)
Push the ignition toggle switch to the Stop position (Figure
27).
Figure 27
1. Ignition toggle switch
Remove the ignition key when you leave the mower.
Important: When you release the blade control
bar, both the engine and blade should stop within 3
seconds. If they do not stop properly, stop using your
mower immediately and contact an Authorized Service
Dealer.
Stopping the Engine (Model
20795 only)
1. Turn the key to the Off position (Figure 28).
Figure 28
2. Remove the ignition key when you leave the mower.
Important: When you release the blade control
bar, both the engine and blade should stop within 3
seconds. If they do not stop properly, stop using your
mower immediately and contact an Authorized Service
Dealer.

Engaging the Blade

When you start your engine, the blade does not turn. You
must engage the blade to mow.
1. Pull the control bar lock back (Figure 29).
11