Table of Contents
Advertisement
Figure 72
1. Disconnected hoses
4. On the other vehicle, connect the two hoses to the
coupler still in the coupler bracket (connect the top
hose to the top coupler and the bottom hose to the
bottom coupler) (Figure 73). Cap the unused fittings.
Figure 73
1. Jumper hoses
5. Keep all bystanders away from the vehicles.
6. Start the second vehicle and move the lift lever to the
raise position which will raise the disabled box.
7. Move the hydraulic lift lever to the neutral position and
engage the lift lever lock.
8. Install the bed safety support onto the extended lift
cylinder. Refer to Using the Bed Safety Support.
Note: With both the vehicles turned off, move the lift
lever back and forth to remove the system pressure and
ease the disconnection of the quick couplers.
9. After completing the operation, remove the jumper
hoses and connect the hydraulic hoses to both vehicles.
2. Jumper hoses
Important: Check the hydraulic fluid levels, in
both vehicles, before resuming operation.
51
Advertisement
Table of Contents
