Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the Traction Control
If traction control does not engage or it slips during
operation, an adjustment is required.
1. Move traction control to Disengaged position.
2. To increase cable tension, loosen front cable jam nut
and tighten back cable jam nut (Figure 48) until a
force of 10-13 lbs. (4.5-5.8 kg) is required to engage
traction control.
Measure the force at the control knob.
Figure 48
1. Traction cable
3. Tighten front cable jam nut.
4. Check control operation.
Adjusting the Reel Control
If reel control does not engage or it slips during
operation, an adjustment is required.
1. Make sure traction control is properly adjusted; refer
to Adjusting the Traction Control.
2. To increase cable tension, loosen front cable jam nut
and tighten back cable jam nut (Figure 49) (located
on top of gear box) until the reel cable force adds
7 to 10 lbs. (3-4.5 kg)of additional handle force
measured at the control knob.
Note: If traction control handle force is 12 lbs., (5.4
kg) the combined traction and reel force should be
19 to 22 lbs. (8.6-10 N-m).
2. Service/parking brake
cable
1. Reel control cable
3. Tighten front cable jam nut.
4. Check control operation.
31
Figure 49
Advertisement
Table of Contents
