Changing The Engine Oil Filter - Toro 74906 Operator's Manual

4. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the Full mark (Figure 51).
1
3
5
5. Start the engine and drive to a flat area. Check the oil
level again.

Changing the Engine Oil Filter

Service Interval: Every 200 hours
Note: Change the engine oil filter more frequently when
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to Changing the
Engine Oil.
2. Change the engine oil filter (Figure 52).
2
4
6
G008796
Figure 51
1
3
5
Note: Ensure the oil filter gasket touches the engine
and then an extra 3/4 turn is completed.
3. Fill the crankcase with the proper type of new oil; refer
to Changing the Oil.
Servicing the Engine Oil Cooler
Service Interval: Every 200 hours
1. Keep the oil cooler free of debris. by cleaning the fins
with a brush.
2. Remove the bolts holding the oil cooler to the engine
housing .
3. Clean the inside of the oil cooler with a brush.
4. Install the oil cooler to the engine housing.
36
2
4
6
3/4
Figure 52
G008804
G008748