Transporting The Machine; Loading The Machine - Toro 74906 Operator's Manual

Transporting the Machine

Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions. Knowing this information could
help you, your family, pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow-moving
vehicle emblem is dangerous and can lead to
accidents causing personal injury.
Do not drive the machine on a public street or
roadway.
To transport the machine:
1. If using a trailer, connect it to the towing vehicle and
connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Stop the engine, remove the key, set the brake, and
close the fuel valve.
5. Use the metal tie-down loops on the machine to
securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes (Figure 38).
1. Tie-down loops
Figure 38

Loading the Machine

Use extreme caution when loading the machine onto a trailer
or truck. One full-width ramp that is wide enough to extend
beyond the rear tires is recommended instead of individual
ramps for each side of the machine (Figure 39). The lower
rear section of the machine frame extends back between the
rear wheels and serves as a stop for tipping backward. Having
a full-width ramp provides a surface for the frame members
to contact if the machine starts to tip backward. If it is not
possible to use one full-width ramp, use enough individual
ramps to simulate a full-width continuous ramp.
The ramp should be long enough so that the angles do not
exceed 15 degrees (Figure 39). A steeper angle may cause
mower components to get caught as the machine moves from
the ramp to the trailer or truck. Steeper angles may also cause
the machine to tip backward. If loading on or near a slope,
position the trailer or truck so that it is on the down side
of the slope and the ramp extends up the slope. This will
minimize the ramp angle. The trailer or truck should be as
level as possible.
Important: Do not attempt to turn the machine while
on the ramp; you may lose control and drive off the side.
Avoid sudden acceleration when driving up a ramp and
sudden deceleration when backing down a ramp. Both
maneuvers can cause the machine to tip backward.
WARNING
Loading a machine onto a trailer or truck increases
the possibility of backward tip-over and could cause
serious injury or death.
• Use extreme caution when operating a machine
on a ramp.
• Ensure that the ROPS is in the up position while
using the seat belt when loading the machine.
Ensure that the ROPS will clear the top of an
enclosed trailer.
• Use only a single, full-width ramp; do not use
individual ramps for each side of the machine.
• If individual ramps must be used, use enough
ramps to create an unbroken ramp surface wider
than the machine.
• Do not exceed a 15 degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
• Avoid sudden acceleration while driving the
machine up a ramp, to avoid tipping backward.
• Avoid sudden deceleration while backing
the machine down a ramp, to avoid tipping
backward.
26