Operation; Rapid Ignition System; Switching On - Miele CS 1011 Operating And Installation Instructions

Operation

Rapid ignition system

The appliance is supplied with a rapid
ignition system with the following fea-
tures:
– Rapid ignition without pressing and
holding the control,
– Automatic re-ignition
Should the flame be extinguished by
a gust of air, the burner will re-ignite
automatically. If re-ignition is unsuc-
cessful, the gas supply will be cut off
automatically (see "Flame failure
monitor").
26

Switching on


Fire hazard.
Do not leave the appliance unatten-
ded whilst it is being used.
 The control for the burner must be
pressed in and turned anti-clockwise
to the large flame symbol to switch
on. The ignitor will "click" and ignite
the gas.
When a control knob is activated, a
spark is developed automatically at all
rings. This is normal and does not in-
dicate a defect.
 If the burner fails to ignite, turn the
control knob to the "" position. Air
the room or wait at least 1 minute be-
fore trying again.
 If the burner does not ignite the
second time, turn the control knob
back to "" and see "Problem solving
guide".
When switching on, re-ignition some-
times occurs (1 - 2 clicks) if the flame
at the thermocouple has extinguished
briefly, or if the thermocouple is not
hot enough, e.g. due to a draught.