Aastra 9480i CT User Manual page 163

Key Function
Private/Public
Flash
Feature Key Programming Guidelines
The following are guidelines to use when programming the feature keys on the handset:
• All handsets paired with the same Base Station have the same programmed functions since the web interface applies
the functions to all the handsets paired with that base.
• A newly registered handset or handset that was out-of-range during the programming needs to perform an "off-hook
and on-hook" sequence in order for the newly programmed function to be broadcast to the affected handsets. Simply
press the v key from the idle state to go off-hook. Then, press the y key to go back on-hook.
• Duplicate functions can exist in the feature key as there is no filtering or duplicate checking done on the handset or the
base.
• If no line keys are programmed for the feature key, the handset is restricted to intercom calls only.
• If all 15 Handset Keys have been programmed to "None", the user is presented with a List empty message when the fea-
ture key is pressed.
• For security reasons, the user has 180 seconds (3 minutes) to complete the programming. Otherwise, the phone dis-
plays the following error:
** Error **: Session expired, Please reload page.
• For security reasons, the user must submit the page from the same browser that was used to load the page. If the user
tries to submit the page from any other IP address, the following error displays: ** Error ** Session invalid. Different
Client IP Addresses. — Please reload page.
41-001381-00 REV01 – 06.2013
Description
Indicates the key is configured for either Private or Public use. You can toggle between
Private and Public as required. Default is Private.
"Private" is the default setting on the Handset. The "Private/Public" option is available
only when multiple handsets are paired with the same base.
In "Public" mode, all handsets paired with the same base can share calls. In this mode,
a triangle indicator illuminates in front of the Public label in the feature list on the
Handset. You can toggle between Public and Private as required. The Base Unit displays
"Private" on a softkey allowing you to toggle between Public and Private.
In "Private" mode set on a specific Handset, all calls are made private to that Handset
only. No calls are shared.
Indicates the key is set to generate a flash event when it is pressed on the 9480i CT. The
IP phone generates flash events only when a call is connected and there is an active RTP
stream (for example, when the call is not on hold).
List empty
Use web page to
configure
Accessing Options on the Cordless Handset
155