Exiting Man Down Feature; Re-Initiating Man Down; Testing The Man Down Feature - Motorola APX 3000 User Manual



Exiting Man Down Feature

If you are not in a real Man Down situation, you should exit the
Man Down feature and prevent emergency from going off with
the following operation.
Procedure:
Repositioning your radio or shaking your radio (when motion
sensitivity is enabled).
OR
Press the preprogrammed Man Down Clear button to exit.


Re-Initiating Man Down

After exiting the Emergency Operation when your radio is still in
Man Down condition (tilted achieving threshold angle or
motionless), reinitiate the Man Down feature by exiting the Man
Down condition.
Procedure:
Return your radio to the vertical position
OR
Shake your radio (when motion sensitivity is enabled).


Testing the Man Down Feature

Note: Enable the Emergency feature with Silent Alarm
disabled, but not in Surveillance Mode before running
this test on your radio.
Procedure:
When Man Down is enabled on your radio:
1
Turn your radio on and place in the vertical position, for at
least 5 seconds.
2
Lay your radio down in the horizontal position.
3
Wait for alert tone.
4
Your radio alerts with audible tone and displays MAN-
DOWN.
OR
If no tone is heard, make sure that the Man Down feature is
enabled on your radio. If Man Down feature was not
enabled, please enable it and go through steps 1,2 and 3
again.
OR
If the Man Down feature is enabled and no tone is heard,
send your radio to a qualified technician.

Handling Man Down Functional Error Messages
Procedure:
1
If your radio display shows one of the following error
messages: HW BOARD ABSENT, MAND HW ERROR or HW
BRD MISMATCH. Send your radio to the qualified technician
to fix this error.
47
English