Download Print this page

Battery Installation; Battery Replacement; Temperature Settings; Telephone Controller - Aube Technologies TH135-01 Installation And User Manual

Aube technologies inc. electronic thermostat installation and user guide

Advertisement

2.3
Pump Protection
For hot water installations, it is recommended
to activate the pump at least one minute
every 24 hours in order to avoid seizure.
Place switch #3 down to activate this function.
For all other installations, leave switch #3 in
the Off position (otherwise your system will be
activated 1 minute every 24 hours).
2.4
Temperature in °C or °F
The TH135 is factory-set to °C. If you wish to
change the temperature display to °F, slide
switch #4 upward. Please note that if you
change from °C to °F or vice versa, you must
reset the Comfort ( ), Economy ( ) and
Vacation (

Battery Installation

Appears when the
setpoint is displayed
Percentage
of heating *
* The thermostat displays the percentage of heating required to maintain the desired tem-
perature. For example,
is displayed when heating is activated at 40 percent.
Display
% of heating
1 to 24% 25 to 49% 50 to 74% 75 to 99%
When you first install the batteries in the TH135, the unit runs a
sequence of tests for approximately 5 seconds. After the tests, the
screen should display the current temperature.
It is normal for the displayed temperature to be higher than the room
temperature if you are holding the TH135 in your hands. It will return
to normal about one hour after installation on the wall.
Mount the thermostat on the wall plate and screw it in place.

Temperature Settings

Preset Temperature
Comfort temperature
Economy temperature
Vacation temperature
To set the Comfort temperature, select the desired degree using
the
buttons and push the
displayed (about 3 seconds).
To set the Economy temperature, select the desired degree
using the
buttons and push the
displayed about 3 seconds).
To set the Vacation temperature, select the desired degree using
the
buttons and push simultaneously the
until the
icon is displayed (about 3 seconds). This setting is
used by the telephone controller.
TH135-01
) settings accordingly.
Temperature display
Preset temperature icon
100%
Default Setting
20 °C (68 °F)
18 °C (64 °F)
10 °C (50 °F)
button until the
icon is
button until the
icon is
and
buttons

Telephone Controller

The TH135 incorporates a telephone controller interface which
allows you to switch from the
(
), and vice versa using a touchtone telephone. You can, for
example, start the heating of your secondary residence from your
office on Friday, or your house from the airport or from your car on
your way back from vacation.
5.1
Connection to the CT240
The TH135 is designed to connect directly to the CT240 telephone
controller. This combination allows the activation and deactivation of
the Vacation setting from the CT240 or telephone.
Connect the CT240's terminals A and C to the TH135's terminals X
and C respectively. You must respect the polarity.
For details on operating the telephone controller, refer to the CT240's
instruction manual.
3.
5.2
Operating the Telephone Interface
You can activate the Vacation setting using the Vacation button of the
telephone controller (
house.
To activate the Vacation setting, press the Vacation button of the
CT240 (
). The Vacation setting will be displayed for 5 seconds
and the (
) icon will flash on the screen. You no longer have
access to the TH135 keypad if this function is activated by the
telephone controller.
To deactivate the function and return to the previous setting,
press the Vacation button of the telephone controller again or
use a phone. The red light will go off and the (
disappear within 5 seconds.
Connection to a Home Automation System
The Vacation setting can also be activated from a home automation
system.
4.

Battery Replacement

The TH135 will display an icon indicating that the
batteries must be replaced. This icon will flash for 60
days. After this period, the thermostat will shut down
your heating unit.
After the battery replacement, you have to
reprogram the
,
4).
Even if the thermostat indicates the batteries are
good, it is recommended to replace them once a
year at the beginning of the heating season.
or
setting to the Vacation setting
) or using a telephone from outside of the
and
settings (refer to section
400-135-000-B
5.
) icon will
6.
7.
11/12/06
2/3

Hide quick links:

Advertisement

loading