Installation - Aube Technologies RLV4305 Owner's Manual

Hg
N O M E R C U RY
SUPPLIED PARTS
One (1) thermostat
•
Two (2) 6-32 mounting screws
•
Two (2) solderless connectors
•

Installation

TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRICAL SHOCK.
All cables and connections must comply with local electrical codes.
•
This thermostat has tinned copper wires for line and load connections.
•
Special CO/ALR solderless connectors must be used if these wires will be
•
connected to aluminium conductors.
Install the thermostat onto an electrical box.
•
Install the thermostat about 5 ft. (1.5 m) high, on an inside wall facing the
•
heater.
Avoid locations where there are air drafts (such as the top of a staircase or
•
an air outlet), dead air spots (such as behind a door), or direct sunlight.
Do not install the thermostat on a wall that conceals chimney or stove pipes.
•
The thermostat wires are not polarized; either wire can be connected to the
•
load or to the power supply.
ATTENTION: MERCURY RECYCLING NOTICE
This product does not contain mercury. However,
this product may replace a product that contains
mercury. Mercury and products containing
mercury should not be discarded in household
trash.
For more information on how and where to
properly recycle a thermostat containing
mercury in the United States, please refer to the
Thermostat Recycling Corporation at
www.thermostat-recycle.org.
For mercury thermostat recycling in Canada,
please refer to Switch the Stat at
www.switchthestat.ca
2