Hardware Setup - Onkyo TXSR307 Instruction Manual

Advanced Setup—Continued

Hardware Setup

This section explains items on the Hardware menu.
8. Hardware
Remote ID
When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate
the AV receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3.
Remote ID 1, 2, 3
Note:
If you do change the AV receiver's remote ID, be sure to change the remote controller to the same ID (see below),
otherwise, you won't be able to control it with the remote controller.
Changing the Remote Controller's ID
1
2
Tuner
FM/AM (North American/Taiwan models)
See "AM/FM Frequency Step Setup (not European models)" on page 42.
AM Freq (Asian model)
See "AM/FM Frequency Step Setup (not European models)" on page 42.
While holding down the [RECEIVER] button, press and hold down the
[SETUP] button until the Remote indicator lights up (about 3 seconds).
Use the number buttons to enter ID 1, 2, or 3.
The Remote indicator flashes twice.
59