Turning On The Av Receiver; Turning On And Standby - Onkyo TXSR307 Instruction Manual

Turning On the AV receiver

ON/STANDBY
STANDBY indicator

Turning On and Standby

AV receiver
or
Up and Running in a Few Easy Steps
To get your system up and running with the minimum of fuss, here's a few pointers to help you configure the AV
receiver before you use it for the very first time. These settings only need to be made once.
■ Do the 2EQ Room Correction and Speaker Setup—this is
essential!
See "Audyssey 2EQ™ Room Correction and Speaker Setup" on page 33.
■ Did you connect a component to component video input or
digital audio input?
If you did, see "Component Video Input Setup" on page 36, or
"Digital Input Setup" on page 36 respectively.
■ Did you connect an Onkyo MD recorder, CD recorder, or RI
Dock?
If you did, see "Changing the Input Display" on page 37.
32
On the AV receiver, press the [ON/STANDBY] button.
Remote
controller
On the remote controller, press the [RECEIVER] button, followed by the
[ON/STANDBY] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
To turn the AV receiver off, press the [ON/STANDBY] button, or press the remote
controller's [ON/STANDBY] button. The AV receiver will enter Standby mode. To
prevent any loud surprises the next time you turn on the AV receiver, turn down the
volume before you turn it off.
ON/STANDBY
RECEIVER
Y
COAXIAL
C P
B B
C P
R R
OPTICAL
OUT IN
MD recorder, CD recorder,
TV/TAPE
RI Dock