Hardware Setup - Onkyo TX-NR828 Owner's Manual

■
Headphone Level
–12dB to 0dB to +12dB
With this setting, you can specify the headphone
volume relative to the main volume. This is useful if
there's a volume difference between your speakers
and your headphones.
OSD Setup
■
On Screen Display
On
Off
This preference determines whether operation details
are displayed on-screen when an AV receiver
function is adjusted.
Even when "On" is selected, operation details may
not be output if the input source is connected to an
HDMI IN.
■
Language
(North American models)
English, Deutsch, Français, Español, Italiano,
Nederlands, Svenska
(European and Australian models)
English, Deutsch, Français, Español, Italiano,
Nederlands, Svenska, Русский язык,
This setting determines the language used for the on-
screen menus.
■
Screen Saver
3min, 5min, 10min
Off
With this setting, you can set the time until the screen
saver activates itself. Once active, the screen saver
will go off and the screen will return to its previous
state if the AV receiver is operated in any way.

7. Hardware Setup

Tuner
■
AM/FM Frequency Step (North American
models)
10kHz/200kHz:
9kHz/50kHz:
Select the frequency step according to your
area.
■
AM Frequency Step (European and Australian
models)
10kHz:
9kHz:
Select the frequency step according to your
area.
For AM/FM tuning to work properly, you must specify
the AM/FM frequency step used in your area.
Note
• When this setting is changed, all radio presets will be
deleted.
HDMI
■
HDMI CEC (RIHD)
Off
On
Turn this setting on to allow
components connected via HDMI to be controlled by
the AV receiver (➔ page 19).
En-74
Note
• When the setting is set to "On" and the menu is closed, the
names of connected
"RIHD On" are displayed on the AV receiver.
"Search..." → "(name)" → "RIHD On"
When the AV receiver cannot receive the name of the
component, it is displayed as "Player
(" * " shows up and indicates the number of components,
when two or more are received).
• When an
the AV receiver via an HDMI cable, the name of the
connected component is displayed on the AV receiver
display. For example, while you are watching TV
broadcasting, if you operate a Blu-ray Disc/DVD player
(being powered on) with the remote control of the AV
receiver, the name of the Blu-ray Disc/DVD player will be
displayed on the AV receiver.
• Set it to " Off "
compatible or it is unclear whether the equipment is
compatible or not.
• If operation is not normal when set to
"
setting to Off
• Refer to the connected component's instruction manual for
details.
• When the "HDMI CEC (RIHD)" setting is set to "On", the
power consumption on standby mode slightly increases.
(Depending on the TV status, the AV receiver will enter
standby mode as usual.)
• The
Use HDMI OUT MAIN instead.
• When the source equipment is connected with the
-compatible connection, it may malfunction if "HDMI CEC (RIHD)" is set
to "On".
Advanced Operations
-compatible components and
* " or "Recorder * ", etc.
-compatible component is connected to
when a connected piece of equipment is not
" On " , change the
"
.
control does not support HDMI OUT SUB.
Operating
procedure
(➔ page 60)