Onkyo TX-SR508 User Manual page 59

When connecting UP-A1 Dock to the radio tuner
UP-HT1 (North American models)/UP-DT1
(European and Asian models) with AUTO selected
by the tuner's Mode Selector switch, you can switch
the input source between UP-A1 Dock and the tuner,
by pressing PORT repeatedly on the front panel.
If you still can't control your iPod, start playback by
pressing your iPod's Play button. Remote operation
should then be possible.
Try resetting your iPod.
Depending on your iPod, some buttons may not
work as expected.
■
The AV receiver unexpectedly selects your iPod
as the input source
Always pause iPod playback before selecting a dif-
ferent input source. If playback is not paused, the
Direct Change function may select your iPod as the
input source by mistake during the transition
between tracks.
Recording
■
Can't record
On your recorder, make sure the correct input is
selected.
When the Pure Audio listening mode is selected,
recording is not possible because no video signals
are output. Select another listening mode.
Zone 2
■
There's no sound
Only components connected to analog inputs can be
played in Zone 2.
Others
■
The sound changes when I connect my
headphones
When a pair of headphones is connected, the listen-
ing mode is set to Stereo, unless it's already set to
Stereo, Mono, Direct, or Pure Audio. (Pure Audio
listening mode is not available for North American
models.)
■
The display doesn't work
The display is turned off when the Pure Audio listen-
ing mode is selected.
■
How do I change the language of a multiplex
source
Use the "Multiplex" setting on the "Audio Adjust"
menu to select "Main" or "Sub".
■
The u functions don't work
To use u, you must make an u connection and an
analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected dig-
itally.
■
The functions and Direct Change don't work for
—
components connected via u
These functions don't work when Zone 2 is turned
on.
■
When performing "Audyssey 2EQ
—
Correction and Speaker Setup", the
measurement fails showing the message
"Ambient noise is too high.".
—
—
This can be caused by any malfunction in your
speaker unit. Check if the unit produces normal
sounds.
■
The following settings can be made for the
composite video inputs
—
You must use the buttons on the unit to make these set-
tings.
1. While holding down the input selector button for the input
source that you want to set, press SETUP.
2. Use e/r to change the setting.
3. Press the input selector button for the input source that you
want to set when you've finished.
• Video Attenuation
This setting can be made for the BD/DVD, VCR/DVR,
—
CBL/SAT, GAME, or AUX input.
If you have a games console connected to the composite
—
video input, and the picture isn't very clear, you can
attenuate the gain.
Video ATT:OFF: (default).
Video ATT:ON: Gain is reduced by 2 dB.
The AV receiver contains a microcomputer for signal
—
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in again.
—
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit's malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
—
let, set the AV receiver to Standby.
37
17
17
®
Room
—
En
59