Digital Input Signal Formats; Adjusting The Bass & Treble - Onkyo TX-SR508 User Manual

Digital Input Signal Formats

The digital input signal formats are available only for the
input sources that you have assigned a digital input jack
(➔ 35).
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the follow-
ing issues when playing PCM or DTS material, you can
manually set the signal format to PCM or DTS.
Note
• If the beginnings of tracks from a PCM source are cut off, try
setting the format to PCM.
• If noise is produced when fast forwarding or reversing a DTS
CD, try setting the format to DTS.
• The setting is stored individually for each input selector.
• The setting will be reset to "Auto" when you change the setting
44).
in the "Audio Selector" (➔
1
Press RECEIVER, and then press and hold
AUDIO for about 8 seconds.
2
While "Auto" lights (about 3 seconds), press e/r
to select:
Auto:
The format is detected automatically. If no dig-
ital input signal is present, the corresponding
analog input is used instead.
PCM:
Only 2-channel PCM format input signals will
be heard. If the input signal is not PCM, the
PCM indicator will flash and noise may also be
produced.
DTS:
Only DTS (but not DTS-HD) format input sig-
nals will be heard. If the input signal is not
DTS, the DTS indicator will flash and there
will be no sound.
Adjusting the Bass & Treble
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio listening mode is
selected.
1
Press TONE on the AV receiver repeatedly to
select either "Bass" or "Treble".
2
Use TONE –/+ on the AV receiver to adjust.
■
Bass
■
Treble
See "Bass" and "Treble" of "Tone Control Settings"
(➔ 43).
Note
• To bypass the bass and treble tone circuits, select the Direct or
Pure Audio listening mode.
• This procedure can also be performed on the remote controller
by using AUDIO 43).
(➔
En
45