Onkyo TX-SR508 User Manual page 48

Controlling Zone 2 with the Remote
Controller
1
Press ZONE2, and then press ON/STANDBY.
Zone 2 turns on, the ZONE 2 indicator lights.
2
To select an input source for Zone 2, press
ZONE2, followed by an INPUT SELECTOR.
To select AM or FM press the TUNER input selector
repeatedly.
(North American models) You can also select SIR-
IUS.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same FM/AM radio sta-
tion will be heard in each room.
3
To turn off Zone 2, press ZONE2 followed by ON/
STANDBY.
Note
• To control Zone 2, you must press the remote controller's
ZONE2 first.
En
48
Adjusting the Volume for Zone 2
■
ON/STANDBY
1
ZONE2
2
INPUT SELECTOR
MUTING
■
VOLq/w
1
2
If your Zone 2 speakers are connected to a receiver or inte-
grated amp in Zone 2, use its volume control to adjust the
volume.
Muting Zones
■
1
2
To unmute a zone
1
2
Note
• Only analog input sources are output by the ZONE 2 LINE
• While Powered Zone 2 is being used, listening modes that
• While Zone 2 is on, u functions will not work.
• You cannot select different AM or FM radio stations for your
• Zones can also be unmuted by adjusting the volume.
Operating with the remote controller
Press ZONE2
Use VOL q/w
Operating on the AV receiver
Press ZONE 2 (the ZONE 2 indicator and Zone 2
selector on the display flashes)
Use –/+ within 8 seconds
Operating with the remote controller
Press ZONE2
Press MUTING
Press ZONE2
Press MUTING again
OUT and FRONT HIGH OR ZONE2 L/R speaker terminals.
Digital input sources are not output. If no sound is heard when
an input source is selected, check if it's connected to an analog
input.
require surround back and front high speakers (6.1/7.1), such as
Dolby Pro Logic IIz Height, Dolby Digital EX, and DTS-ES are
unavailable.
main room and Zone 2. The same FM/AM radio station will be
heard in each room. For example, if you have an FM station for
the main room, that station will also be used in Zone 2.