Replacing The Drive Belts; Replacing The Headlight Bulb - Toro 38820 Operator's Manual

Figure 51
2. Loosen the bolt on the cable clamp
Figure 52
1. Cable conduit
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth
Figure 53
1. Discharge chute latch
Note: The latch is spring loaded and will naturally
move into the teeth of the gear
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp, being careful not
to strip the plastic part.
6. Install and secure the gear cover.
(Figure 52).
2. Cable clamp
(Figure 52 and Figure 53).
2. Gear teeth
(Figure 53).

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 899 37W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure
2. Turn the base of the bulb counterclockwise until it
stops (Figure 55).
3. Remove the bulb straight out from the back of the
headlight (Figure
4. Insert a new bulb into the back of the headlight
57).
24
54).
Figure 54
Figure 55
56).
Figure 56
(Figure