Figure 57
5. Turn the base of the bulb clockwise until it is snug
(Figure
58).
Figure 58
6. Insert the wire connector straight into the back of the
headlight until it is securely in place
Figure 59
Storage
• Gasoline vapors can explode.
• Do not store gasoline more than 30 days.
• Do not store the machine in an enclosure near
• Allow the engine to cool before storing it.
Preparing the Machine for
Storage
1. On the last refueling of the year, add fuel stabilizer to
2. Run the engine for 10 minutes to distribute the
(Figure
59).
3. Run the machine until the engine runs out of fuel.
4. Prime the engine and start it again.
5. Allow the engine to run until it stops. When you can
6. Stop the engine and allow it to cool.
7. Remove the ignition key.
8. Clean the machine thoroughly.
9. Touch up chipped surfaces with paint available from an
10. Tighten all loose screws, bolts, and locknuts. Repair or
11. Cover the machine and store it in a clean, dry place out
Removing the Machine from
Storage
Perform the annual maintenance procedures as given in the
Recommended Maintenance Schedule.
25
WARNING
an open flame.
fresh fuel.
Note: Fuel should not be stored longer than suggested
by the fuel stabilizer manufacturer.
conditioned fuel through the fuel system.
no longer start the engine, it is sufficiently dry.
Authorized Service Dealer. Sand affected areas before
painting, and use a rust preventative to prevent the
metal parts from rusting.
replace any damaged parts.
of the reach of children.