Minimum Speaker Impedance Setup; Not North American Model - Onkyo TX-SR503E Instruction Manual

First Time Setup
2–8
RETURN

Minimum Speaker Impedance Setup

(not North American model)

If the impedance of any of the connected speakers is 4
ohms or more, but less than 6 ohms, set the Minimum
Speaker Impedance to "4 ohms."
Note:
Before you change this setting, turn down the volume.
1
Press the [RECEIVER] button followed
by the [SETUP] button.
2
Use the Up and Down [
to select "0. Hardware Setup," and then
press [ENTER].
3
Use the Left and Right [
to select the setting for "Impedance."
4 ohms: Select if the impedance of any con-
nected speaker is 4 ohms or more, but
less than 6 ohms.
6 ohms: Select if the impedances of all con-
nected speakers are between 6 and
16 ohms.
Press [RETURN] to continue with step 2 in the
"Speaker Configuration" setting.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
32
ON STANDBY
REMOTE MODE
1
RECEIVER DVD
TAPE/AMP
INPUT SELECTOR
M D
CD
1 2 3
CDR
V 1 V 2 V 3
T V
4 5 6
MULTI CH DVD
7 8 9 VCR
TAPE TUNER CD
+ 10
0 CLR
SAT
10 11 12
CABLE
--/---
DIMMER SLEEP
CH
T V VOL VOL
DISC
INPUT
GUIDE PREVIOUS
TOP MENU MENU
SP A / B MUTING
ENTER
1, 9
RETURN SETUP
LISTENING MODE
STEREO SURROUND
]/[ ] buttons
]/[ ] buttons
Speaker Configuration
This section explains how to specify which speakers are
connected and their sizes.
For speakers with a cone diameter
larger than 6-1/2 inches (16 cm),
specify Large. For those with a
smaller diameter, specify Small.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
2
Use the Up and Down [
buttons to select "1. Speaker
Config," and then press the
[ENTER] button.
3
While the Subwoofer setting is
selected, use the Left and Right
[ ]/[ ] buttons to select
.
Yes: Select if a subwoofer is con-
No: Select if no subwoofer is con-
4
Use the Down [
select "Front," and then use the
Left and Right [
select
Small: Select if the front speakers are
Large: Select if the front speakers are
Note:
• If the Subwoofer setting in step 3 is
set to No, this setting is fixed at Large
and does not appear.
Cone diameter
]/[ ]
nected.
nected.
] button to
]/[ ] buttons to
or .
small.
large.
or