Optional Brick Panels; Log Set Installation - FPI P36D-NG1 Owners & Installation Manual

Direct vent gas fireplace
Hide thumbs Also See for P36D-NG1:
Table of Contents

Advertisement

OPTIONAL
BRICK PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
Note: The logs must not be in the unit.
2) Insert the back brick panel fi rst by carefully
slipping it between the back wall of the fi rebox
and the rear log bracket.
3) Put the side panels in next. Slide them in
from the front and push them fl at up against
the wall. Be very careful not to scratch them
on the fi rebox hardware.
4) Install the 2 brick retaining clips, one on
each side.
Note: If the bottom brick panel must be removed:
Remove the Rear Log Stand, then remove
the Burner Tray.
FPI P36D-1 Zero Clearance Direct Vent Gas Fireplace
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
The gas log kit (Part # 780-930) contains the
following pieces:
a) 02-75
Rear Log
b) 02-55
Middle Left Log
c) 02-50
Front Left Log
d) 02-53
Center Left Log
e) 02-51
Front Bottom Log
f)
02-54
Center Right Log
g) 02-52
Middle Right Log
h)
Embers
02-55
02-75
02-50
02-53
02-51
The "02" refer numbers (i.e. 02-75) are
molded into the rear of each log.
NOTE: If you will be installing the optional
Brick Panels, install the Brick Panels
prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite all over the top of
the base brick panel.
3) Place the Log 02-75 on the rear log support
pins with the fl at side to the back.
02-75
INSTALLATION
4) Place Log 02-51 on the front right side of
the burner. Push the back of the log against
the 2 brackets with the notch on the bottom
right side of the log fi tting into the right side
of the grate.
02-75
Bracket
02-51
02-52
5) Position Log 02-53 across the cut outs in
Logs 02-75 and 02-51 with the notch on the
left side of the log fi tting into the 2nd grate
tab.
02-54
2nd Grate Tab
6) Position Log 02-54 across the cutouts in
Logs 02-51 and 02-53. The notch in the
bottom right end fi tting against the 5th grate
tab.
02-51
Bracket
Notch
Notch
02-53
02-75
02-51
Cutouts
02-51
02-53
39

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

P36d-lp1

Table of Contents