Other Functions; Display Device Code - SUPPORTPLUS URC-0401 Manual

ol 2. Point the remote control at your device. Press down and hold the SET key and press the de-
er vice key (e.g. TV) in a short time (less than 3 seconds, otherwise it goes to Auto Search), then
u release the both pressed keys.
3. The device key lights up continuously and the remote control is then in setting-up mode.
Actuate the POWER key (ON/OFF key) about every 1.5 seconds. (If the device being sought
4.
it
is a video recorder, DVD player, CD player, TUNER, TAPE or AUX, you may press the
PLAY key also.), the device key now flashes, that means it is in Manual Search mode.
n-
5. Once the searched device switches off (or reacts), test the functions of other keys (don't
ce
press POWER key, in case it goes to next code) on the remote control. If most of them do not
function properly, press the POWER key about every 1.5 seconds again to call up the next
code (continues the Manual Search, see step 4-5).
If you feel most of keys on the remote control work good enough, you can save the code by
pressing the device key (e.g. TV) to finish the Manual Search.
n
Note:
The Manual Search will be automatically terminated if no entry within 30 seconds.
e.
l-

Other Functions

n
A. Display Device Code:
de
y)
The device code, which has been set up in your new remote control, can be called up as follows:
1. Press the SET key and hold it down, now actuate number key "1" to display the 100th
er
position of 3-digit code. Count the numbers that the LED flashes. If the LED doesn't flash,
p
that means the digit is ZERO.
n
2. Similarly, press the SET key and hold it down, at the same time actuate number key "2" to
display the 10th position of 3-digit code.
g.
Press the SET key and hold it down, at the same time actuate number key "3" to display the
3.
1st position of 3-digit code.
is
Example for Code 028:
a. Press SET and "1"
LED flashes 0 time, no flashes.
b. Press SET and "2"
o
LED flashes 2 times.
c. Press SET and "3"
e.
LED flashes 8 times.
9