Operation Instructions; Set Up; Set Up By The Brand Code - SUPPORTPLUS URC-0401 Manual

ie

OPERATION INSTRUCTIONS

Thank you for purchasing this 4 in 1 universal remote control. Your new remote control contains
one of the largest infrared code library for 4 different devices obtainable in Europe.
This remote control unit is preprogrammed, all you have to do is to choose the device that you wish
to control (for example TV) and it's 3-digit code number from the brand code list (for example
001 under Philips TV). After you set up it will remember all your set up data permanently even
you remove the batteries later.
te
The 4 in 1 universal remote control is suitable for practically all common brands of television
en
set (TV), DVD player (DVD), digital and analogue satellite receiver and cable box (CBL/SAT),
ng
video recorder (VCR).
This 4 in 1 universal remote control unit operates almost all the basic functions of your devices.
Please read these operation instructions before using your new 4 in 1 remote control.
n.

Set up:

en
Make sure that 2 new batteries (type "AAA") have been inserted correctly into your new remote
control unit.
er
To make your remote control ready for use, you need to carry out one of the following steps:
en
en
A. Set up by the Brand Code:
1. Switch on the device that you would like to control (e.g. TV set).
ie
2. In the back section of this manual, find the name and code no of your device brand (e.g.
tz
Philips 001, 004, 016...). Note the codes must be in the column for the corresponding device
group (TV).
3. Hold down the SET key and actuate the device key (e.g. TV) at the same time. The TV
device key on your remote control lights up, which means it is in the setting up mode.
4. You must now enter the 3-digit device code (e.g. 001 for Philips TV) within 10 seconds. If no
entry within 10 seconds, the setting up mode is automatically terminated.
5. The LED goes out if the code has been accepted by the remote control. If the LED flashes
twice, which means the code may be wrong, and the remote control remains in set-up mode,
you should enter the correct code from the list again in time.
7
GB