Reset / Delete Function; Write-Protection Of Device Codes; Service Adresse - SUPPORTPLUS URC-0401 Manual

B. Reset / delete function:
To delete the codes which have been set up in the remote control, press and hold down the SET
key, press the "0" key simultaneously for more than 3 seconds and then release the both pressed
keys. The LED will flash twice and all the set up data in the remote control are deleted.
Note:
Please don't operate this function if you don't want to delete all the settings.
C. Write-protection of device codes:
To protect the device codes from being inadvertently overwritten / deleted, you can carry out the
following:
1. Press the device key (e.g. TV) that you would like to protect on your remote control.
2. Press and hold down the SET key and press the "7" key at the same time. Then release
the both pressed keys, the LED will flash twice and the code is then protected from being
overwritten/deleted.
Note:
To cancel write protection, press the SET key and hold it down, and activate the "8" key at the same time,
then release the both pressed keys. The LED flashes twice and the protection has been cancelled.

Service Adresse:

European Distribution Center
Londoner Straße 11
D- 48455 Gildehaus
Germany
Tel. Nat. / internat.: 00800/ 7777 88 99
E-Mail: Service@SupportPlus.org
10
N
M
co
so
C
p
d
ra
su
L
té
et
L
v
té
C
A
n
P
d
A
1
2
3
4
5