Set Up By Auto Search; Setting Up By Manual Search - SUPPORTPLUS URC-0401 Manual

6. Check the function of the keys on remote control. If most keys on your new remote control
do not function correctly, try another 3-digit device code (e.g. 004...) from the list under
the same brand. Repeat steps 3 to 6 until all the basic functions operate correctly.Once you
satisfy the code, that means you have already got correct set up for this device.
Note:
To leave set-up mode, press the device key (e.g. TV). or if you do not actuate any keys within 10 seconds it
will be automatically terminated.
You may set up more than one device on the new remote control. Before you operate your new remote con-
trol normally, please press the requested device key first, so the remote control is surely at the proper device
status, otherwise it may control the wrong device which is not your requested.
B. Set up by Auto Search:
If setting up with brand name and codes is unsuccessful, or you can not find your brand name in
the list, you can use the "Auto Search" to establish the correct code for your remote control.
1. Switch on the device that you like to control. If it is a video recorder, insert a video cassette.
Point the remote control at your device. Press the SET and the device (e.g. TV) key simul-
2.
taneously and hold them down for 3 seconds. Then the device key flashes, that means it is in
Auto Search now.
3. The OFF signal is automatically transmitted to the device from the remote control (code
scan). Once the device(e.g. TV) switches off, immediately press any key (except SET key)
to stop the Auto Search.
4. Switch the device on again by pressing the „POWER" key. Check the function of the other
keys on the remote control unit. If all the keys do not function (that means you may not stop
the search in time), or most keys' operation is not good enough, you can start the search again
(see steps 2–4) to find a suitable code.
If most keys function properly, that means your set up is successful, press the device key (e.g.
TV) again to save the code and finish the set up.
Note:
To abort the Automatic Search, press any key (except set key). The LED lamp will go out and the search is
terminated. If no key pressed within 30 seconds, the search will automatically quit also.
C. Setting up by Manual Search:
If setting up with brand name and codes is unsuccessful, you can also use the "Manual Search" to
find the correct code for operating your device.
1. Switch on the device that you like to control. If it is a video recorder, insert a video cassette.
8
2.
3.
4.
5.
N
Th
O
A
T
1.
2.
3.
E
a.
b.
c.